User's Manual

2140-72018-00-0A REV: A Page 2 Of 38
Note:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may
cause undesired operation.
WARNING! Changes or modifications to this unit not expressly approved by Telematics
Wireless Ltd. could void the user's authority to operate the equipment.
The digital portion of the transceiver has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by the following
measure:
-Increase the separation between the equipment and receiver.
The antenna and therefore the unit, used for this transmitter must be installed to normally provide
minimum separation distance of at least 2 meters from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
The Reader is sold with power cable with molded ferrite that provide common-mode filtering.
Recommended ferrite manufacturer: Fair-Rite, part number: 0444164281.
The communication cables shall be installed by professional installer, placing ferrites on the cables
that are supplied with unit.
Recommended ferrite manufacturer: Fair-Rite, part number: 0444164281.