User's Manual

FP300RA User Manual
2140-72018-00-0A REV: A Page 14 Of 38
Chapter 2: Installation
2.1 General
This Chapter provides the information needed to install FP-300RA readers.
The information presented in this Chapter is organized as follows:
• Installation requirements – Section 2.2.
• Installation guidelines – Section 2.3.
• Installation procedures – Section 2.4.
Before starting the installation procedures, make sure to review the Safety Information
section at the beginning of this manual.
2.2 Installation Requirements
2.2.1 Integration in Systems
Figure 2-1 shows the connections needed to integrate an FP-300RA unit in a typical electronic
vehicle identification system. Use the information appearing in Chapter 1 and Appendix A,
that covers the FP-300RA interface characteristics and connection data, to prepare cables in
accordance with the specific requirements of each location.
1
2
3
4
I/O
MULTILANE ANT
DC IN
AUX
HOST
MAINTENANCE
FP-
300RA
To Maintenance PC
To Auxiliary
Devices
To Host Computer
To DC Power Source
(8 - 30V)
To Main
Antenna
To Sensors
& Controlled Devices
MAIN ANT
To Secondary
(Lane) Antennas
Figure 2-1: FP-300RA Connections