User's Manual

FP200INT User Manual

2.2 Attached the T-Seal int and Magnet on Container Doors

The 2

phase is installing the T-Seal int and the sensor’s magnet in the container.

Step 1: Attach the T-Seal int’s on the container right

door (looking from inside) 5 inches from the

door top and as close as possible to the door

edge.

Step 2: Attach the magnet on the other door 7 inches

from the door top and as close as possible to

the door edge.

Note:

All surfaces must be clean and dry prior to

3M Dual Lock™ tape application.

The T-Seal int antenna (“finger”) shall be

aligned with the rubber seal of the container

door.

The magnet shall be below the T-Seal int

antenna.

Step 3: Close the doors and “Search” for the

T-Seal int using the HH reader, select it and

verify that the door sensor is enabled and

secure (GREEN)

If the door sensor is still tampered (RED) then open

the container doors and verify the T-Seal int and

magnet are in the right position.

2140-72017-00-0A REV: C Page 7 Of 10