User's Manual

FP200HH User Manual
2.2 Charging
The HH Reader has a single charger for both the iPAQ and the reader electronic board. The
charger connector is located in the HH Reader bottom side.
Open the black rubber cover on the bottom side of the HH Reader – See Fig.8.
Connect the charger to charger connector of the HH Reader, – See Fig.9.
Wait for the power indicator of the iPAQ, see Fig.10, to stop blinking and turn ON constantly.
Now the HH Reader is fully charged.
Note:
When operating from battery, this indicator is OFF.
`
Charger
Connector
Bottom
Cover
Fig. 8:
Bottom cover Fig.9: Charger connector
Fig.10:
Charger indicator
2140-72017-00-0A REV: D Page 7 Of 8