Quick Start Guide

FUNKTIONSMENUE
INSTALLATION
Connections
Plug the handset cord to the connector of the fax (1).
Plug the telephone line cord to the connector (2) of the machine and connect the
other end to the wall telephone socket.
Plug the power supply unit to the connector (3) and the power cord into an A.C.
outlet .
Ink ribbon
Open the front and the back cover (4, 5).
Place the ink ribbon kit above its housing under the back cover (6).
Put it in its housing without removing the adhesive tape.
Remove the adhesive tape .
Place the small roll in its housing (7).
Installing the ribbon gauge.
Remove gauge housing cover (8):
. slide the cover towards the back,
. remove the gauge mini-card (9) from the support card (10).
Insert the gauge (9) in the slot (11) of its housing with the chip facing you and the
bevelled corner positioned on top right.
Replace the gauge housing cover (8).
Close the back cover (5), then the front cover (4).
8
11
9
10
8
4
5
6
7
QUICK USER GUIDE TO CUT OFF
3 1
2