User manual
- 20 -
The receiver can output RGB and CVBS signal from the TV SCART on the rear panel. Although the RGB
format results in a better quality picture, not all equipment can cope with an RGB signal.
Prefer Dolby Digital
Use “ ” or “ ” button to select Dolby Digital and then press “ ” or “ ” button to set this setting as Yes or No.
Digital Audio Output
Use “ ” or “ ” button to select S/PDIF Output and then press “ ” or “ ” button to set this setting as LPCM
or Dolby Digital.
HDMI Resolution
By pressing “ ”/ “ ” on the remote control, you can change to HDMI resolution as 576P, 720P, 1080i or 1080P.
AUDIO Delay
First press OK and than by pressing “ ”/“ ” buttons on the remote control, you can set to Audio Delay to
desired value. You can use this setting when there is a synchronization problem in the received broadcast .
Press “ ” or “ ” button to change the delay.
Note:This function will be available while using Optical Audio out only.
Receiver Upgrade
To ensure that your STB always has the most up to date information. Please ensure that after use it is set to its standby
mode.
• Press Menu button and using the “ ”/“ ” buttons to choose Setup and press the OK button.
• Highlight Conguration menu with “ ”/“ ” keys and pres OK.
• Use “ ”/“ ” buttons to choose “Receiver Upgrade” and press OK button.
• Using the “ ”/“ ” button you can change “Automatic scanning” Enabled or Disabled.
• Highlight “Scan for upgrade” menu with “ ”/“ ” keys and press OK to commence upgrade.
• Highlight “Edit upgrade” menu with “ ”/“ ” keys and press OK to change upgrade options. Please enter your available
satellite information and save all values all select reset and press OK to re enter.
Parental Control
Highlight Parental Control and press “OK” to enter. To display Parental Control menu options, the PIN code
should be entered. After entering the correct PIN Parental Control menu will be displayed.
Note: The factory default PIN is 0000.