Owner's manual

iv
Model 3000MB
Teledyne Analytical Instruments
Table of Contents
1 Introduction
1.1 Overview ........................................................................ 1-1
1.2 Typical Applications ....................................................... 1-1
1.3 Main Features of the Analyzer ....................................... 1-1
1.4 Model Designations ....................................................... 1-2
1.5 Front Panel (Operator Interface) ..................................... 1-3
1.6 Interface Panel ............................................................... 1-5
2 Operational Theory
2.1 Introduction .................................................................... 2-1
2.2 Precise Paramagnetic Sensor........................................ 2-1
2.2.1 Principles of Operation ............................................ 2-1
2.3 Cross Interface ............................................................... 2-3
2.4 Sample System.............................................................. 2-5
2.5 Electronics and Signal Processing ................................ 2-6
3 Installation
3.1 Unpacking the Analyzer................................................. 3-1
3.2 Mounting the Analyzer ................................................... 3-1
3.3 Rear Panel Connections ................................................ 3-2
3.3.1 Primary Input Power............................................... 3-4
3.3.2 Fuse Installation..................................................... 3-4
3.3.3 Anolog Outputs ...................................................... 3-4
3.3.4 Alarm Relays................................................................. 3-6
3.3.5 Digital Remote Cal Input............................................. 3-7
3.3.6 Range ID Relays.......................................................... 3-9
3.3.7 Network I/O.................................................................... 3-9
3.3.8 R/S-232 Port................................................................. 3-9
3.3.9 Remote Sensor and Solenoid Valves....................... 3-10
3.4 Gas Connection .............................................................3-12
3.5 Test The System.....................................................................3-14
4 Operation
4.1 Introduction .................................................................... 4-1
4.2 Using the Data Entry and Function Buttons ................... 4-2
4.3 The System Function ..................................................... 4-3
4.3.1 Setting the Display................................................. 4-4
4.3.2 Setting up an Auto-Cal........................................... 4-5
4.3.3 Password Protection .............................................. 4-5