User manual
WaveSurfer 3000/3000z Oscilloscopes Operator's Manual
3. Check ViewMask to display the mask over the trace.
Tip: Select the mask file and touch Delete to remove it from the directory.
Remove a Mask from the Display
Touch the Delete Mask button at the left of the Pass/Fail dialog.
Run Test
1. Make or load a mask.
2. On the main section of the Pass/Fail dialog, select the condition of the signal that, when "True",
constitutes a "Pass" (samples are All In(side mask), All Out(side mask), etc.).
3. Select any actions to take when the test produces this result:
l Save a waveform file
l Stop the test
l Sound an Alarm
l Emit a Pulse from Aux Out(put)
l Capture the screen and process it according to your Hardcopy(Print) setting
l Create a LabNotebook Entry
4. Choose to turn Markers Off or On. When "On", points where the signal intersects the mask are
marked by a red circle.
5. Check the Testing box at the far left of the Pass/Fail dialog. The results of your test will appear in a
table below the grid as soon as there is a fresh acquisition.
90