User manual

WaveSurfer 3000/3000z Oscilloscopes Operator's Manual
Renaming Digital Lines
The labels used to name each line can be changed to make the user interface more intuitive.
1. Touch Label and select from:
l Data - the default, which appends "D." to the front of each line number.
l Address - appends "A." to the front of each line number.
l Custom - lets you create your own labels line by line.
2. If using Custom labels:
l Touch the Line number field below the corresponding checkbox. If necessary, use the
Left/Right Arrow buttons to switch between banks.
l Use the virtual keyboard to enter the name, then press OK.
Also, labels can be "swapped" between lines. This procedure helps in cases where the physical lead
number is different from the logical line number you would like to assign to that input. It can save time
having to reattach leads or reconfigure groups.
Example: A group is set up for lines 0-4, but lead 5 was accidentally attached to the probing point. By
"swapping" line 5 with line 4, you do not need to change either the physical or the logical setup.
1. Select a Label of Data or Address.
2. Touch the Line number field below the corresponding checkbox. If necessary, use the Left/Right
Arrow buttons to switch between banks.
3. From the pop-up, choose the line with which you want to swap labels.
36