User manual

Oscilloscope Set Up
Language Selection
To change the language of the oscilloscope application:
1. Go to Utilities > Preference Setup > Preferences and make a Language selection.
2. Follow the prompt to restart the application.
Auto Setup
Auto Setup configures the essential acquisition settings based on the first input signal it finds, starting with
C1. If nothing is connected to C1, it searches C2 and so forth until it finds a signal. Vertical Scale (V/div),
Offset, Timebase (Time/div), and Trigger are set to an Edge trigger on the first, non-zero-level amplitude,
with the entire waveform visible for at least 10 cycles over 10 horizontal divisions.
To run Auto Setup, simply press the front panel Auto Setup button.
Recall Default Setup
Restore the factory default settings by pressing the front panel Default Setup button. Confirm the action.
You can also restore default settings via the touch screen by choosing File > Recall Setup from the menu
bar and touching the Recall Default button.
13