User manual

WaveSurfer 3000/3000z Oscilloscopes Operator's Manual
Australia & New Zealand Declaration of Conformity– EMC
The instrument complies with the EMC provision of the Radio Communications Act per the following
standards, in accordance with requirements imposed by Australian Communication and Media Authority:
AS/NZSCISPR11:2011RadiatedandConductedEmissions,Group1,ClassA.
AUSTRALIA / NEW ZEALAND CONTACTS:*
RS Components Pty Ltd.
Suite 326 The Parade West
Kent Town, South Australia 5067
RS Components Ltd.
Unit 30 & 31 Warehouse World
761 Great South Road
Penrose, Auckland, New Zealand
*Visit teledynelecroy.com/support/contact for the latest contact information.
Safety Compliance
EC Declaration of Conformity– Low Voltage
The instrument meets intent of EC Directive 2014/35/EU for Product Safety. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for measurement, control, and laboratory
use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for measurement, control, and
laboratory use – Part 2-030: Particular requirements for testing and measuring circuits
The design has been verified to conform to the following limits put forth by these standards:
l Mains Power Supply Circuits: Overvoltage Category II, instrument intended to be supplied from the
building wiring at utilization points (socket outlets and similar).
l Measuring Circuit Terminals: No rated measurement category. Terminals not intended to be directly
connected to the mains supply.
l Unit: Pollution Degree 2, operating environment where normally only dry, non-conductive pollution
occurs. Temporary conductivity caused by condensation should be expected.
U.S. NationallyRecognized Agency Certification
The instrument has been certified by Underwriters Laboratories (UL) to conform to the following safety
standard and bears UL Listing Mark:
UL 61010-1 Third Edition – Safety standard for electrical measuring and test equipment.
124