User manual

WaveSurfer 3000z Getting Started Guide
27
BASICS
Enter measurement Gates in divisions,
or just drag gate markers from edge of
grid to set gates.
Measurements & Statistics
Measurements are waveform parameters that can be expressed as numerical values, such as amplitude or frequency. You can set up-to-six
simultaneous measurements on one or more traces and view the active readout in a table below the grid. Statistics can be added to the readout along
with histicons, a miniature histogram of the statistical distribution. You can also gate measurements to limit them to a specific portion of the trace or
plot the trend of the measurement over time.
Measure > Measure
Setup opens the
Measure dialog.
Add/remove Satistics
and Histicons.
Touch Measure column
to re-open Measure dialog
if closed.
Choose Measurement and Source
trace to be measured.
Clear Sweeps to restart
measurements..