User manual

Part 6: IEEE 488.2 Command Reference
Measurement Mnemonic Qualifiers
Histogram left bin; same as
Histogram minimum.
LOW <source>
Mathcad parameter MATHCADPARAMARITH <source>,'<function>'
MATLAB parameter MATLABPARAM <source>,'<function>'
Histogram maximum
population
MAXP <source>
Median MEDI <source>
Histogram mode MODE <source>
Narrow Band phase NBPH
<source><frequency HZ>
Narrow Band power NBPW
<source><frequency HZ>
N cycle jitter NCYCLE <source>
VBS script parameter PARAMSCRIPT <source>,'<code>'
Histogram percentile PCTL <source>
Number of peaks PKS <source>
Number of points PNTS <source>
Population of histogram bin
at
x
POPATX <source>,<cursorposition V>
<cursorposition>:= value V representing histogram bin at which to
measure population
Histogram range RANGE <source>
Rise time @ level RLEV <source>,<lowlevel PCT | V>,<highlevel PCT | V>
Data edge to clock edge SETUP <clocksource>,<clockslope>,<clocklevel PCT | V>,
<datasource>,<dataslope>datalevel PCT | V>,
<clockhysteresis DIV>,<datahysteresis DIV>
Histogram standard
deviation
SIGMA <source>
Time Interval Error @ level TIELEV
<signaltype>,<slope>,<level PCT | V>,<outputin>,<hysteresis
DIV>,<referencetype>,<-3db@frequency HZ>,<frequency HZ>
Histogram total population TOTP <source>
Width @ level WIDLV <source>,<slope>,<level PCT | V>,<hysteresis DIV>
Pos of max. data value XMAX <source>
Pos of min. data value XMIN <source>
Histogram
N
th highest peak XAPK <source>
6-63