User manual

MAUI Oscilloscopes Remote Control and Automation Manual
CURSOR Commands and Queries
CURSOR_MEASURE, CRMS
Description
The CURSOR_MEASURE command specifies the type of cursor or parameter measurements to be
displayed and is the main command for displaying parameters and Pass/Fail test results.
The CURSOR_MEASURE? query indicates which cursors or parameter measurements are currently
displayed.
Command Syntax
CURSOR_MEASURE <mode>[,<submode>]
<mode>:= {CUST, FAIL, HABS, HPAR, HREL, OFF, PASS, VABS, VPAR, VREL}
<submode>:= {STAT, ABS, DELTA, SLOPE}
Where:
l CUST[,STAT] shows user-defined (My Measure) parameters.
l FAIL shows measurements failing Pass/Fail test.
l HABS shows Horizontal Absolute cursors.
l HPAR[,STAT] shows Standard Horizontal parameters.
l HREL[,ABS,DELTA,SLOPE] shows Horizontal Relative cursors.
l OFF turns off cursor and parameter display.
l PASS shows measurements passing Pass/Fail test.
l VABS shows Vertical Absolute cursors.
l VPAR[,STAT]shows Standard Vertical parameters.
l VREL[,ABS,DELTA] shows Vertical Relative cursors.
The submode STAT is optional with modes CUST, HPAR, and VPAR. If present, STAT turns on parameter
statistics display. Absence of STAT turns off parameter statistics.
The submodes ABS and DELTA are optional with modes HREL or VREL. If present, ABS reads absolute
position of relative cursors, whereas DELTA reads the delta of the two cursors. Absence of keyword
selects the DELTA.
The modes PARAM, SHOW DASH, and LIST used with some legacy LeCroy instruments are not available
on MAUI instruments.
6-50