User manual

WaveSurfer 3000 Oscilloscopes
Individual traces are resized to fit the total number of divisions available. The example above shows a
group of three Line traces plus the Bus trace occupying a Group Height of 4.0 divisions. Each trace takes
up one division.
5. Check the Group box to enable the display.
To close traces, uncheck the Group box.
Renaming Digital Lines
The labels used to name each line can be changed to make the user interface more intuitive. Also, labels
can be "swapped" between lines.
Changing Labels
1. Set up the digital group.
2. Touch Label and select from:
l Data - the default, which appends "D." to the front of each line number.
l Address - appends "A." to the front of each line number.
l Custom - lets you create your own labels line by line.
3. If using Custom labels:
l Touch the Line number button below the corresponding checkbox. If necessary, use the Left/Right
Arrow buttons to switch between banks.
l Use the virtual keyboard to enter the name, then press OK.
The button and any active line traces are renamed accordingly.
Swapping Lines
This procedure helps in cases where the physical lead number is different from the logical line number you
would like to assign to that input (e.g., a group is set up for lines 0-4, but lead 5 was accidentally attached to
the probing point). It can save time having to re-attach leads or re-configure groups.
1. Select a Label of Data or Address.
2. Touch the Line number button below the corresponding checkbox. If necessary, use the Left/Right Arrow
buttons to switch between banks.
3. From the popup, choose the line with which you want to swap labels.
The button and any active line traces are renumbered accordingly.
32