User manual

Assembly Instructions

3. Place the oscilloscope inside the rackmount in front of the two, pre-installed positioning brackets on the side plates. The

screen should be visible through the front plate.

NOTE: You may need to loosen and rotate the positioning brackets to fully insert the body of the oscilloscope into

the rackmount.

4. Tilt the entire rackmount forward until it rests on its handles. This should cause the oscilloscope to lie flush with

the front plate.

5. Slide each positioning bracket forward so that it is flush to the back of the oscilloscope and tighten it.

6. With the rackmount securely fastened to the unit, install the WaveSurfer 3000 into a rack following the

manufacturer's specifications.