Manualshelf

User manual

ManualsBrandsTELEDYNE LECROY ManualsLaboratory Test EquipmentDigital 200 MHz 4-channel 2 GSa/s 10 Mpts 8 Bit Digital storage (DSO)
919293949596979899100
Operator's Manual
Remote Control Settings
The Remote dialog contains settings to configure remote control of the instrument and also network access.
Supported remote control protocols are:
l TCPIP (Ethernet). If you choose this option, also install Teledyne LeCroy's VICP drivers on the
controller. These are included in the VICP Passport plug-in, available free from teledynelecroy.com.
The instrument uses Dynamic Host Configuration Protocol (DHCP) as its default addressing protocol,
although you can manually assign a static IP address.
l USBTMC
Assign Static IP Address/Name Server
Before starting, consult with your Network Administrator regaring the oscilloscope's network address,
subnet, default gateway.
NOTE: You can also use this procedure to assign a name server if your network uses DHCP addressing.
1. Connect a keyboard to the front panel USB port.
2. From the menu bar, choose Utilities > Utilities Setup, then touch the Remote tab.
3. On the Remote dialog, touch Net Connections.
4. Touch the SMSC icon.
87