User manual

Operator's Manual
A unique feature of the WaveScan Zoom is that you can automatically zoom the events captured from the
source trace by touching the Prev/Next buttons on the Zx dialog. You can also select the event from the
Table display, and you are automatically relocated to that event on the zoom trace.
Setting Up WaveScan
This procedure explains how to set up WaveScan to search an acquisition for events of interest. Set up your
source channel and triggers before setting up the scan.
1. Press the front panel Stop button to stop acquisition.
2. Choose Analysis > WaveScan.
3. Check Enable.
4. Choose the Source waveform.
5. Choose the Scan Mode and enter values for any additional settings that appear at the right of the dialog
based on your selection.
6. If you're using Measurement Mode, set up the filter in one of the following ways:
l Touch Filter and choose an operator, then enter the Filter Limit.
l Touch Filter Wizard and choose one of the pre-set filters. The Filter and Filter Limit are
automatically set based on your selection.
7. Select each Scan View in which you wish to display results by checking the box at the bottom of the
dialog. Each view selected is displayed simultaneously.
8. Optionally, choose an Action to trigger when an event that meets your scan criteria is found.
9. Restart acquisition.
10. When using the Zoom view, use the WScanZx tab to adjust the zoom.
85