Manualshelf

User manual

ManualsBrandsTELEDYNE LECROY ManualsLaboratory Test EquipmentDigital 200 MHz 4-channel 2 GSa/s 10 Mpts 8 Bit Digital storage (DSO)
101102103104105106107108109110
WaveSurfer 3000 Oscilloscopes
If desired, enter a Default Recipient Address (To:) All email sent from the oscilloscope will go to this address
unless manually changed.
Click Send Test Mail to send a confirmation message to ensure proper e-mail configuration.
Miscellaneous Settings
These other Preference settings are located on the Miscellaneous dialog.
To add the Teledyne LeCroy logo to print output, check Print Teledyne LeCroy Logo When Printing Grid Area
Only. This identifies the instrument as the source of the image.
You can adjust zoom behavior as follows:
l Dimming darkens/shades those areas of the source waveform that are not part of the Zoom trace.
l Control Sensitivity adjusts the sensitivity of the front panel knobs. Optimized applies an acceleration
algorithm to the knobs. Legacy detects rotation of the front panel knobs in a manner similar to our
legacy oscilloscopes.
Serial Decode Annotation Position: If you have Serial Trigger or Decode options installed on your
oscilloscope, this control determines the placement of annotation labels relative to the trace line. It does not
appear if there are no installed options.
l On Trace places the label close to the line.
l On Noisy Trace sets the label further from the line to accommodate potential noise spikes in the trace.
Check Enable HTTP Screen Capture to enable remote capture of the oscilloscope display over a netowrk.
This setting is required to use the oscilloscope with the WaveStudio software.
96