User manual

Description

The front panel has the following indicators and connectors:

Connector 1 LED (Green - Good)

(Red - Flip it over!)

Analyzer Connector 1 (downstream) Connects to Device under test (UFP).

Power LED (Green if on)

Status LED (Blue if system successfully initializes)

(Red while booting. If red for more than a minute, hardware failure)

(Green while initializing)

Analyzer LEDs

Trig - Trigger (Green if triggering)

Rec - Recording (Red if recording enabled)

Analyzer Connector 2 (upstream) Connects to Host under test (DFP).

Connector 2 LED (Green - Good)

(Red - Flip it over!)

The rear panel has the following indicators and connectors:

Aux: 9-pin Mini DIN connector, used for External Trigger In and Out BNC

connections. (Cable sold separately - AC032XXA‐X)

USB: Type C connector for connection to host computer running USB

Protocol Suite

Warning: Do not open the enclosure. No operator serviceable parts are inside.

Refer servicing to Teledyne LeCroy customer care.

Installing the Software

Note: You must install the software before connecting the Analyzer to the host machine for the first time.

Refer to the System Requirements in the readme file for information about the exact Windows

operating systems supported.

1. Insert the installation disc into the host machine's DVD drive.

2. Typically, the installation process will automatically start. If it doesn't, browse to the 'Autorun' folder

on the installation disc, then double-click the 'autorun.exe' file.

3. Follow the on-screen instructions to complete the installation.

Note: If you get an error message during installation of the drivers, consult your system administrator.