Data Sheet

TeledyneLeCroyCorporation VoyagerM3xAnalyzer
100 USBProtocolSuiteUserManual
Note:USB2.0LinkLEDsoperateonlywhileUSB2.0RecordingorReal‐Time Statistics(RTS)isrunning.
USB3.1LEDsalwaysoperate,unlessUSB3.1hasbeendisabledintheRecordingOptions
GeneralTab.
WARNING: DonotopentheVoyagerM3xenclosure.Nooperatorserviceablepartsare
inside.ReferservicingtoTeledyneLeCroycustomercare.
2.8.4 Specifications
TheAnalyzerhasthefollowingspecifications.
Power Requirements
12VDC,5amps.
In SMAexternaltriggerinput.Note:Edge
detected.(Risingedgeonly)Voltagerequired:
Signalneedstobe>800mVtoseealogic"1",
Signalneedstobe<400mVtoseealogic"0".
Maximumvalueoftheexternalinputsignal
whichcanbeinputis5V.Minimumvalueis0
V.
Out SMAexternaltriggeroutput.
PulseWidth=280ns.PulseVoltage=3.3
Voltsinto1MegOhms.PulseVoltage=2.7
Voltsinto50Ohms.Pulseispositivegoing.
RearPanel:
SyncIn ForuseinDaisychainingandCrossSync
scenarios.
SyncOut ForuseinDaisychainingandCrossSync
scenarios.
ETHERNET GigabitEthernetforconnectiontohost
machine.
USB USB3.1SuperSpeedStandardBConnectorto
hostmachine.
DCIN 12V,5Apowersupplyconnector.
PowerSwitch (0/1)Off/On