Data Sheet

USBProtocolSuiteUserManual 93
MercuryT2C TeledyneLeCroyCorporation
2.6.5 Mercury T2C System Setup
MercuryT2CisconfiguredandcontrolledthroughahostmachineUSBport.
Figure 2.18: Mercury T2C Setup
TheDevice(UFP)shouldbereconnecttotheConnector1(Leftside),whereastheHost
(DFP)shouldbeconnectedtoConnector2(Rightside).Thedeviceandhostshouldbe
connectedtothecablesbeforeinsertingintotheAnalyzer,sotheorientationandUFPvs
DFPaspectcanbedetermined.ThenthecablescanbeconnectedtotheMercuryT2C.If
theLEDassociatedwiththeConnectorshowsRed,youneedtofliptheconnectoroverso
itshowsGreen.Thewillenabletheanalyzertoconnectalltheothersignalsina3.1cable
correctly,allowingtheotherSS,SS+,orAlternateModestoworkwithoutinterruption.