Data Sheet

USBProtocolSuiteUserManual 295
RecordingRules‐USB3.1SS+(VoyagerM310/M310Conly),USB3.1SS(Voyager/AdvisorT3only) TeledyneLeCroyCorporation
5.10.4 Dragging a Button to the Main Display Area
AfteryoucreateanEventbuttonintheAvailableEventsarea,youcandragthebuttonto
theMainDisplayareaanddropitintheappropriatecell(acellisagrayed‐outrectangle
withadashedlinearoundit).Youcanthinkofeachcellasatargetfordrag‐and‐dropofan
Eventbutton(seeFigure 5.60onpage 295.)
Therearetwotypesofcellthatmightappear:SequencecellandStatecell.Inthe
Main Displayarea,theyarelabelledasfollows:
 Sequencecell:Draganeventheretoaddanewsequence.
 Statecell:Draganeventheretoaddanotherstate.Note:RecordingRulesfor
USB 3.1currentlydonotsupportmorethantwoindependentstates.
Figure 5.60: Sequence and State Cells.
IftherecurrentlyarenoeventsintheMainDisplayarea,asinglesequencecellappearsat
thetopofthearea.
Todrag‐and‐droptheEventbutton,see“DraggingaButtontotheMainDisplayArea”on
page271