Data Sheet

USBProtocolSuiteUserManual 149
ApplicationStartup TeledyneLeCroyCorporation
3.5.3 IP Settings (Voyager only)
Ifconnectedtoadevice,youcanchangetheIP settings:
 DHCPautomaticallyassignsanIPaddress.DHCP isthedefault.
 StaticIPpromptsyoutoenteraspecificIP address.
TochangefromDHCPtoStaticIPwhileconnectedtoadevice:
1. SelectSetup>AllConnectedDevicesfromthemenubartodisplaythe
Analyzer Devicesdialog.
Figure 3.41: Analyzer Devices Dialog.
Note:Ifyouarenotconnectedtoadevice,theIPSettingscommandisgrayedout.
2. Selectthedevicetouseintherecording,thenclicktheIPSettingsbuttontodisplay
theDeviceIPSettingsdialog.
Figure 3.42: Device IP Settings Dialog
Tworadiobuttonsareavailable:
 ObtainIPaddressautomatically(DHCP)[default]
 UsethefollowingIPAddress(StaticIP)