Data Sheet

TeledyneLeCroyCorporation SettingUptheAnalyzer‐EthernetConnection
140 USBProtocolSuiteUserManual
Ethernet Direct Connection
1. MakesuretheUSBcableisNOTattachedthetheUSBAnalyzer.
2. NowyoucanattachanethernetcablefromyourhostPCtotheanalyzerandpower
cycletheanalyzer.
3. Waitfortheanalyzertoinitialize(theblueLEDwillcomeonafterinitialization)
andstartuptheUSBProtocolSuitesoftware.
4. Select“Setup‐>AllConnectedDevices”andthenselecttheanalyzeryouwantto
connectto.TheConnecttabwillbehighlighted.SeeFigure 3.38.
Figure 3.38: USB Analyzer with New IP Address Connected Over an Ethernet bus