Instructions
T3VNA User Manual V
AC Power
Input Voltage & Frequency: 100-240 V at 50/60/400 Hz
Automatic AC selection.
Power Consumption: 35 W maximum
Mains Supply Connector: CAT II per IEC/EN 61010-1:2015, instrument
intended to be supplied from the building wiring at utilization points (socket
outlets and similar).
Fuse Type
100 V / 110 V : 1.25A / 250 V (âTâ rated)
220 V / 230 V : 1.25A / 250 V (âTâ rated)
1 General Inspection
Please check the instrument according to the following steps.
1. Inspect the shipping container.
Keep the shipping container and packaging material until the contents of the shipment
have been completely checked and the instrument has passed both electrical and
mechanical tests. It is always good practice to save the shipping container and
packaging for use when returning the power supply to Teledyne LeCroy for service or
calibration.
The consigner or carrier will be responsible for damage to the instrument resulting from
shipping. Teledyne LeCroy will not provide free maintenance or replacement in this
instance.
2. Inspect the instrument.
If the instrument is found to be damaged, defective or fails in electrical or mechanical
tests, please contact the Teledyne LeCroy service department immediately.
3. Check the accessories.
Please check that you have received the accessories: Calibration Kit, Utility Kit, Power
Cord, USB cable. If the accessories are incomplete or damaged, please contact
Teledyne LeCroy immediately.