Instructions

T3VNA User Manual 39
2.2.6.3 Limit2
Enable or disable limit2.
2.2.6.4 Limit2 Edit
Edit the properties of limit2.
Table 2-22 Limit2 Edit Menu
Function Explanation
Type Select upper or lower limit type. The default value is Lower.
Mode Select limit line or limit point. The default value is Line.
Set the number of the point to be edited if you selected the point type, and
the range is 1 - 100.
Add point Add a new point for editing.
X-axis Edit the X-axis value (frequency or time) of the current point.
Amplitude Edit the amplitude of the current point or line.
Del Point Delete the point whose number is selected in Mode.
Del All Delete all points.
Save/Load Save or load the limit file.
2.2.6.5 Test
Enable or disable the limit test function.
2.2.6.6 Setup
1. Fail to stop
Turn on or off the Fail to stop function. If the function is on, the analyzer will stop sweep and retain the
test result when the test result is “Fail”.
2. Buzzer
Turn on or off the buzzer. When the buzzer is on, it beeps when the test result is “Fail”.
3. X Axis
Set the X-axis to frequency or time domain. The default value is Freq.
Note that all the points of the current limit line will be deleted if the X-axis unit changes.
2.2.7 TG (Tracking Generator)
Set the parameters related to the tracking generator (TG) and normalize.