Instructions

T3VNA User Manual 9
4 5
Figure 1-10 Front Panel Connectors (2)
4. TG SOURCE, VNA PORT 1
 The TG SOURCE can be connected to a device-under-test (DUT) through a cable with a male
N-type male connector.
 In the VNA mode, this port is used as the single port of S11 and the output port of S21.
CAUTION
To avoid damaging to the tracking generator, the reverse DC voltage cannot
exceed 50 V
5. RF INPUT, VNA PORT 2
 The RF INPUT can be connected to the DUT through a cable with a male N-type connector
 In the VNA mode, this port is used as the input port for S21 measurements.
CAUTION
To avoid damaging to the instrument, the RF input signal must meet the
following: The DC voltage component and the maximum continuous power
of the AC (RF) signal component cannot exceed 50 V and +30 dBm
respectively.