Datasheet

11
UART / RS232 Trigger
Condition Start, Stop, Data, Parity Error
Source (RX/TX) All channels
Data format Hex
Limit Range =, >, <
Data Length 1 byte
Data Width 5 bit, 6 bit, 7 bit, 8 bit
Parity Check None, Odd, Even
Stop Bit 1 bit, 1.5 bit, 2 bit
Idle Level High, Low
Baud (Selectable) 600/1200/2400/4800/9600/19200/38400/57600/115200 bit/s
(Custom) 300 bit/s ~ 5,000,000 bit/s
CAN Trigger
Condition Start, Remote, ID, ID + Data, Error
Source All channels
ID STD (11 bit), EXT (29 bit)
Data Format Hex
Data Length 1~2 byte
Baud Rate (Selectable) 5 k/10 k/20 k/50 k/100 k/125 k/250 k/500 k/800 k/1 M bit/s
LIN Trigger
Condition Break, Frame ID, ID+Data, Error
Source All channels
ID 1 byte
Data Format Hex
Data Length 1 ~ 2 byte
Baud Rate (Selectable) 600/1200/2400/4800/9600/19200 bit/s
Baud Rate (Custom) 300 bit/s ~ 20 kbit/s
Serial Decoder
I2C Decoder
Signal SCL, SDA
Address 7 bits, 10 bits
Threshold -4.5 ~ 4.5 div
List 1 ~ 7 lines
SPI Decoder
Signal SCL,MISO, MOSI, CS * NOTE 2 channel scopes can only use 2 signal identiers
Edge Select Rising, Falling
Idle Level Low, High
Bit Order MSB, LSB
Threshold -4.5 ~ 4.5 div
List 1 ~ 7 lines
UART / RS232 Decoder
Signal RX, TX
Data Width 5 bit, 6 bit, 7 bit, 8 bit
Parity Check None, Odd, Even
Stop Bit 1 bit, 1.5 bit, 2 bit
Idle Level Low, High
Threshold -4.5 ~ 4.5 div
List 1 ~ 7 lines
CAN Decoder
Signal CAN_H, CAN_L
Source CAN_H, CAN_L, CAN_H-CAN_L
Threshold -4.5 ~ 4.5 div
List 1 ~ 7 lines
LIN Decoder
LIN Specication Package Revision Ver1.3, Ver2.0
Threshold -4.5 ~ 4.5 div
List 1 ~ 7 lines