User Manual

PP019/PP020 Passive Probe
EC Declaration of Conformity
The product is marked with this symbol to indicate that it conforms to
the applicable European Union requirements per Low Voltage
Directive (LVD) 2006/95/EC. Compliance was demonstrated to the
following specification as listed in the Official Journal of the European
Communities:
EN 61010-031/A1:2008 Safety requirements for electrical equipment for
measurement, control and laboratory use – Part 031: Safety requirements for
handheld probe assemblies for electrical measurement and test.
EU RoHS Compliance
The probe and its accessories conform to the 2011/65/EU RoHS2 Directive, as
they have been classified as Industrial Monitoring and Control Equipment (per
Article 3, Paragraph 24) and are exempt from RoHS compliance until 22 July 2017
(per Article 4, Paragraph 3).
General Safety Information
Observe generally accepted safety procedures in addition to those listed
here to avoid personal injury or damage to equipment. The overall safety
of any system incorporating this accessory is the responsibility of the
assembler of the system.
Connect only to grounded instruments. Use only with compatible Teledyne LeCroy
oscilloscopes that have their BNC input connected to an earth ground. Do not
connect the probe reference lead to any point which is at a potential other than
earth ground.
Connect and disconnect properly. Connect probe to the oscilloscope before
connecting it to the test circuit. Disconnect the probe input and reference lead
from the test circuit before disconnecting from the oscilloscope. Do not connect
or disconnect probes while they are connected to a voltage source.
4 923445-00 Rev A