Datasheet

D11000PS DIFFERENTIAL PROBE SYSTEM
238 1-800-5-LeCroy
PROBES AND
PROBE ACCESSORIES
Reproducing accurate serial data eye patterns requires maintaining precise magnitude
and phase relationships between the fundamental and the odd harmonics. The advanced
calibration system used in the D11000PS assures the best eye pattern fidelity.
Superior Probe Loading Characteristics
Accurate frequency response is not enough to assure good waveform fidelity.
Excessive probe loading can cause waveform distortion. The D11000PS continues
the legacy of LeCroy high-performance probe design, placing special emphasis on
minimizing loading of the circuit under test.
The Solder-In lead and dedicated probe amplifier module have a high input resistance
at DC and low frequencies, allowing the probe to be used in circuits which cannot
drive the low resistance of a pure transmission line probe. The direct cabled SMA
inputs have 50 Ω input impedance with low VSWR.
Ease of Use
Attention to fine details during the D11000PS design process has resulted in several
“ease of use” features. A common mode measure feature allows the user to measure
the average common mode component with a single click in the probe control menu.
AutoColor ID lights an indicator in the probe body, matching the color of the waveform
trace. When multiple channels are used, this feature instantly identifies which wave-
form corresponds to which probe.
Several connection accessories designed specifically for the D11000PS provide
convenient and secure mounting of the probe body and Solder-In tip to the test circuit.
DC blocking adapters extend the common mode range of the SMA cabled input for
use with higher common mode voltages such as Digital Video Interface (DVI). A finger
wrench allows tightening of SMA connectors on dense test fixtures.