User manual

1. Select the frame where the change should take effect
2. Select Set Subsequent Decoder Parameters from the
Options menu, or by selecting a frame in the frame display
and choosing from the right-click pop-up menu, and make the
needed changes. Refer to
3. Change the L2CAP parameter by selecting from the rule to
change, and click on the listed parameters.
4. If you wish to remove an overridden rule click on Remove
Override button. If you want to remove all decoder
parameter settings click on Remove All.
5. Click OK.
Each entry in the Set Subsequent Decoder Parameters dialog
takes effect from the specified frame onward or until redefined in
this dialog on a later frame.
Note: If the capture has no user defined overrides, then the
system displays a dialog stating that no user defined overrides
exist.
3.2.4 RFCOMM Decoder Parameters
3.2.4.1 About RFCOMM Decoder Parameters
Each entry in the Set Initial Decoder Parameters dialog takes effect from the beginning of the capture onward
or until redefined in the Set Subsequent Decoder Parameters dialog.
Figure 3.15 - RFCOMM parameters tab
The RFCOMM Set Initial Decoder Parameters tab requires the following user inputs to complete a
parameter:
l Stream - Identifies the role of the device initiating the frame (master or slave)
l Server Channel - The Bluetooth® channel number 0 through 78
l DLCI - This is the Data Link Connection Identifier, and identifies the ongoing connection between a client and
a server
Chapter 3 Configuration Settings TELEDYNE LECROY
Frontline BPA low energy Hardware & Software User Manual 27