User manual

Single File
Figure 7.1 - System Settings Single File Mode
This option allows the analyzer to capture data to a file. Each time you capture the file you must provide a file
name. The size of each file cannot larger than the number given in File Size (in K). The name of each file is the
name you give it in the Name box followed by the date and time. The date and time are when the series was
opened.
l
Restart Capturing After Saving or Clearing Capture File
If the Automatically Restart feature is enabled, the analyzer restarts capture to the file immediately after the
file is closed.
l
Wrap File
When enabled, the analyzer wraps the file when it becomes full. The oldest events are moved out of the file
to make room for new events. Any events moved out of the file are lost. When disabled, the analyzer stops
capture when the file becomes full. Either reset the file or close your capture file to continue.
l File Size: The size of the file will depend of the available hard disk space.
1. Click the Min button to see/set the minimum acceptable value for the file size.
2. Click the Max button to see/set the maximum acceptable value for the file size.
TELEDYNE LECROY Chapter 7 General Information
191 Frontline BPA low energy Hardware & Software User Manual