Owner's manual

OPERATOR’S MANUAL

The TDP Series Software

The TDP option adds the following capability to the LeCroy oscilloscope software user interface dialogs:

1. Serial Trigger

Selection

If this is the first serial trigger option you

have installed on your scope, an

additional icon appears in your trigger

dialog box. It allows a serial trigger

condition to be set from within the

oscilloscope using an easy-to-

understand interface.

2. Serial Decode If this is the first serial decode option

you have installed on your scope, an

additional set of Serial Decode and

Decode Setup dialog boxes are

provided for setup of protocol format (as

necessary) and decoding. These can be

accessed from the Analysis menu.

3. Decode Protocol

Selections

FlexRay is one of several signal types

that can be decoded by the

oscilloscope. Other standards in I

SPI, UART, RS-232, CAN and LIN.

4. Physical Layer Test Eye diagram and physical layer

measurement parameters are accessed

through the Serial Decode setup by

selecting the Physical Layer Tab

FlexRay-TDP-OM-E Rev A 5