Users Manual Instruction Manual

CATC FIREINSPECTOR 2.01 CHAPTER 2

User’s Manual Getting Started

Note: The FireInspector analyzer box must be attached to the computer via the USB cable and powered on

before updating the driver.

2.5.1 Updating the Driver on Windows 2000

Step 1 Select Start > Settings > Control Panel from the desktop taskbar, then

double-click on Add/Remove Hardware in the Control Panel window.

The Add/Remove Hardware Wizard will open.

Step 2 Click Next.

Step 3 Choose “Uninstall/Unplug a device” and click Next.

Step 4 Choose “Unplug/Eject a device” and click Next.

Step 5 Select CATC FireInspector IEEE 1394 Bus Analyzer from the list of devices

and click the Properties button.

The Properties window will open.

Step 6 Select the Driver tab in the Properties window and click Update Driver.

The Upgrade Device Driver Wizard will open.

Step 7 Click Next.

Step 8 Choose “Display a list of the known drivers for this device so that I can

choose a specific driver.” Then, click Next.

Step 9 Choose “Have disk” and click Next.

The Install from Disk window will open.

Step 10 Install from Disk 1 of the FireInspector installation diskette set:

Make sure that the disk is in the computer’s floppy drive, then select the drive

from the drop-down list or type the drive letter (e.g., “a:”) in the combo box,

then click OK.

Install from a directory on the computer’s hard drive:

Browse or enter the path to the Disk 1 directory of the FireInspector

installation, then click OK.

The Install from Disk window will close.

Step 11 Select CATC FireInspector IEEE 1394 Bus Analyzer from the list of devices

in the Upgrade Device Driver Wizard and click Next.

Step 12 Click Next to install the driver.

Step 13 Click Finish to close the Wizard.

Step 14 Check the driver version on the Driver tab of the Properties window to make

sure that the driver was successfully upgraded.

Step 15 Close the remaining open windows.

2.5.2 Updating the Driver on Windows 98 SE

Step 1 Select Start > Settings > Control Panel from the desktop taskbar, then

double-click on System Properties in the Control Panel window.

The System Properties window will open.