Manual

Operator’s Manual
922258-00 Rev A 83
European Contact:
Teledyne LeCroy Europe GmbH
Waldhofer Str 104
D-69123 Heidelberg
Germany
Tel: [phone]
AUSTRALIA & NEW ZEALAND DECLARATION OF CONFORMITY – EMC
Amplifier complies with the EMC provision of the Radio Communications Act per the following
standards, in accordance with requirements imposed by Australian Communication and Media
Authority (ACMA):
CISPR 11:2003 Radiated and Conducted Emissions, Group 1, Class A, in accordance with EN61326-
1:2006 and EN61326-2-1:2006.
Australia / New Zealand Contacts:
Vicom Australia Ltd.
1064 Centre Road
Oakleigh, South Victoria 3167
Australia
Vicom New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand
Safety Compliance
EC DECLARATION OF CONFORMITY – LOW VOLTAGE
The amplifier meets intent of EC Directive 2006/95/EC for Product Safety. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for measurement, control, and
laboratory use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for measurement, control, and
laboratory use – Part 2-030: Particular requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the following limits put forth by these
standards:
 Overvoltage Category II: equipment intended to be supplied from the building wiring with a
nominal supply voltage up to 300V.
 Measurement Category 0: amplifier measurement terminals that are not intended to be
directly connected to the MAINS supply.
 Pollution Degree 2: an operating environment where normally only dry, non-conductive
pollution occurs. Occasionally a temporary conductivity that is caused by condensation
must be expected. This location is a typical office/home environment.