Operators Manual User guide

Operator's Manual
CANbus-TD-TDM-OM-E RevB
55
2. The housing is shipped with two of the plastic
end caps (that cover the screws) uninstalled. If
these have been installed by you or someone
else, you will need to remove them with a small
screwdriver or knife.
3. Unscrew the screws on the DSUB-9 connector
side of the Trigger Module using a Philips #1
screwdriver.
4. Slide the tray out of the housing (you may have
to pull with some force if it has not been opened
before).