Users Manual Instruction Manual

CATC BTTRAINER 2.20 CHAPTER 5

User’s Manual Command Generator

5.3 Commands Available in Command Generator

The following tables summarize the commands in Command Generator.

For detailed descriptions of the commands, see Appendix A: Command Generator

Command Descriptions, on page 83.

Note: “N/A” means Not Applicable. This indicates that the specified command does not have a parameter.

5.3.1 HCI Commands

Link Control Commands

Two sections of Link Control Commands are presented. The first section lists commands

that are supported by BTTrainer. The second section presents commands that are not

supported.

Table 5-1: Supported HCI Link Control commands

Commands Parameters

Accept_Connection_Request Request_Role_Switch

Add_SCO_Connection HCI_Handle

Packet Type

Authentication_Requested HCI_Handle

Change_Connection_Link_Key HCI_Handle

Change_Connection_Packet_Type HCI_Handle

Packet_Type

Create_Connection BD_ADDR

Packet_Type

Page_Scan_Rep_Mode

Page_Scan_Mode

Clock_Offset

Allow_Role_Switch

Disconnect HCI_Handle

Exit_Periodic_Inquiry_Mode N/A

GetSCOConnection N/A

Inquiry Inquiry_Length

Num_Responses

LAP

Inquiry_Cancel N/A

Master_link_Key Key_Flag

Periodic_Inquiry_Mode Max Period Length

Min Period Length

Inquiry Length

Num of Responses

LAP

PIN_Code_Request_Negative_Reply BD_ADDR