Users Manual Instruction Manual

CATC BTTRAINER 2.20 CHAPTER 3

User’s Manual Local Device Manager

• LMP Version: The Current Link Manager Protocol version (VersNr) in the

BTTrainer hardware. Can be 0 (Bluetooth LMP 1.0), 1 (Bluetooth LMP 1.1), or

2-255 (reserved for future use)

• Manufacturer Name: The name of the company (CompID) that created the LMP

Subversion.

• LMP Subversion: The Current Link Manager Protocol subversion in the BTTrainer

hardware.

• Connection_Accept_Timeout —The value of the Connection_Accept_Timeout parame-

ter, which specifies the amount of time that BTTrainer will wait to to accept a connec-

tion after sending a connection request.

• Page_Timeout — The value of the Page_Reply_Timeout parameter, which specifies the

amount of time that BTTrainer will wait for a response to a connection request before

returning a connection failure.

• Page_Scan_Period_Mode — The value of the mandatory Page_Scan_Period_Mode

parameter, which specifies the value for the T_mandatory_pscan timer. Possible values:

• 0x00: PO

• 0x01: P1

• 0x02: P2

• 0x03–0xFF: Reserved

• Page_Scan_Mode — The value of the Page_Scan_Mode parameter, which is the default

page scan mode for BTTrainer. Possible values:

• 0x00: Mandatory Page Scan Mode

• 0x01: Optional Page Scan Mode I

• 0x02: Optional Page Scan Mode II

• 0x03: Optional Page Scan Mode III

• 0x04–0xFF: Reserved

• PIN_Type — The PIN type specified in the BTTrainer host controller. Possible values:

• 0x00: Variable PIN

• 0x01: Fixed PIN

• Authentication_Enable — The value of the Authentication_Enable parameter, which

specifies whether BTTrainer will try to authenticate a remote device at connection

setup. Possible values:

• 0x00: Authentication disabled

• 0x01: Authentication enabled for all connections

• 0x02–0xFF: Reserved

• Encryption_Mode — The value of the Encryption_Mode parameter, which specifies

whether BTTrainer requires encryption for connections with remote devices. Possible

values: