Users Manual Instruction Manual

282
CATC BTTRAINER 2.11 CHAPTER
User’s Manual
Test
Scenario
1 Byte
0x00 Pause Test Mode Values defined for LMP_TestControl command.
This parameter defines the transmitted data type
and the loopback mode.
0x01 Transmitter test – 0
pattern
0x02 Transmitter test – 1
pattern
0x03 Transmitter test – 1010
pattern
0x04 Pseudorandom bit
sequence
0x05 Closed Loop Back –
ACL packets
0x06 Closed Loop Back –
SCO packets
0x07 ACL Packets without
whitening
0x08 SCO Packets without
whitening
0x09 Transmitter test – 1111
0000 pattern
0xFF Exit Test Mode
0x0A-
0xFF
Reserved
Hopping
Mode
1 Byte
0x00 Tx/Rx on a single
frequency
Values defined for LMP_TestControl command
0x01 Europe/USA
0x05 Reduced hopping
0x06-0x
FF
Reserved
TxFrequency
1 Byte
Example: 0x01 Values defined for LMP_TestControl command.
Valid only in a single frequency mode.
RxFrequency
1 Byte
Example: 0x02 Values defined for LMP_TestControl command.
Valid only in a single frequency-hopping mode.