Users Manual Instruction Manual

97
CATC BTTRAINER 2.20 APPENDIX A
User’s Manual
A.6.3 Write_Loopback_Mode
The Write_Loopback_Mode will write the value for the setting of the Host Controller’s
Loopback_Mode into BTTrainer.
A.7 CATC-Specific HCI Commands
A.7.1 CATC_Change_Headset_Gain
Controls the gain of the microphone or speaker of the headset.
A.7.2 CATC_Decrease_Power_Request
Send LMP_Decr_Power_Req PDU to the remote device.
Command Parameters Examples Comments
Loopback_Mode 0 0x00=No Loopback mode
enabled. Default
0x01=Enable Local Loopback
0x02=Enable Remote Loopback
Return Events
Write_Loopback_Mode_Complete
Write_Loopback_Mode_Error
Command Parameters Examples Comments
Device “Speaker” “Microphone” or “Speaker”
(“Speaker” is default)
Gain 0 0x00 - 0x0F
Return Events
CATC_Change_Headset_Gain_Complete
CATC_Change_Headset_Gain_Error
Command Parameters Examples Comments
HCI_Handle
Return Events
Command Status: Will return after the operation has started.
Command Complete: Will return after the operation has completed.