User manual

Operator’s Manual
922244-00 Rev A
31
B
11. Press to add a digital waveform to the Waveform List:
 When the New Waveform window appears, press to add all
buses/signals to the digital waveform.
 Enter either the time length or the number of samples under
Waveform Length.
 Press OK to add the waveform to the Waveform List.
12. Press or double-click on Waveform1 to open the Editing
Waveform window.
13. Set WR, RD, and WriteRAM signals to 1 by selecting the “to 1”
button.
14. Expand the Data field and change CLK signal to HiZ. This changes the
pin direction from output to input. Press OK.
15. Select Waveform1 from the Waveform List and press to add it
to the sequencer.
16. Connect the digital leads from POD A to the digital signals, being
sure to connect each channel to the same channel it was associated
with in the ArbStudio software.
17. Press and allow ArbStudio to run long enough to capture
the applied digital data. Press to stop the acquisition.
18. View the acquired data by selecting Waveform View under the
Acquisition folder of POD A, then selecting to add the data to
the signal selection.