User manual

Operator’s Manual
922244-00 Rev A
29
B
10. On the Device Control Tree, double click the Settings item under
Channel 1.
11. On the General tab of the DEV1 Settings Ch 1 screen, select the
appropriate Output Impedance value for your impedance load.
Example: When connecting ArbStudio to an oscilloscope, a 50 Ohm
output impedance load is selected here and 50 Ohms is also selected
as the input impedance on the oscilloscope channel.
12. On the Run Mode tab, select Single for the Run Mode field value
and click the OK button.