User Manual

OPAL SERIES USER GUIDE www.teledex.com 17
Unpacking Your Telephone
This package should contain the following:
• Telephonebaseunit
• Handset
• Coiledhandsetcord
• 1straightlinecord
Optional items to be ordered separately:
• Wallmountadaptorbracket
• Shortlinecordforwallmounting
Installation
CAUTION INFORMATION
• Neverinstalltelephoneornetworkwiring
during a lightning storm.
• NeverinstalltelephoneorEthernetjacksin
wet locations unless the jack is specifically
designed for wet locations.
• Nevertouchuninstalledtelephonewiresor
terminals unless the telephone line has been
disconnected at the network interface.
• Usecautionwheninstallingormodifying
telephone and network lines.
CONNECTING THE HANDSET CORD
A 10 ft. modular handset coil cord is provided.
To install, simply plug one end of the coil cord
into the jack at the base of the handset, and the
other end into the jack located on the end of the
telephone base marked Handset.
CONNECTING THE LINE CORD
A 15 ft. modular line cord is provided. To install,
simply plug one end of the cord into the modular
jack at the top end of the base unit and the other
end into the wall jack.
Features
1. Speed-Dial Memory Keys: 6,11, or 0
user-programmable speed-dial keys with
32 digit capacity. [Flash] and [Pause] are
storable. Speed-dial memory is non-
volatile RAM, so programming is retained
without the need for batteries or telephone
line power.
2. Line 1 Key: Press Line 1 to place a call to
a party on Line 1. Place the call on hold if
you want to initiate a call on Line 2.
3. Line 2 Key: Press Line 2 to place a call to
a party on Line 2. Place the call on hold if
you want to initiate a call on Line 1.
4. CONF (Conference) Key: The Conf
key allows three-way conversations.
Depending on the situation, you may
initiate a conference call using one of
these methods:
5. FLASH Key: Generates a 600 ms (0.6
seconds) hook switch “tap” signal.
Utilized to access special features on
PBX systems. The Flash function is
programmable at 100 ms to 1000Ms
(default is 600 ms). This button is located
underneath the faceplate.
6. REDIAL Key: Redials the last-dialed
telephone number, up to 32 digits.
7. MUTE Key: Sets the microphone Mute
function On and Off. The LED indicator
above the [Mute] key displays the On/
Off status of the Mute function. When
Mute is On, the handset and hands-free
microphone audio is turned off. You will be
able to hear the party at the other end of
your call, but they will not be able to hear
you.
OPAL SERIES 2LINE CORDED AND TRIMLINE PHONES