User's Manual
Table Of Contents
- Copyright
- Disclaimer
- Emissions
- Table of Contents
- TS4000 Overview
- Configuration Program
- Serial Port
- Radio Setup
- AirNet Packet Protocol
- Overview
- Configuration Options
- Control and Status Strings
- Master-Slave System Setup
- Polled System with Store and Forward Repeaters
- CSMA System Setup
- GPS Configuration
- Testing
- Remote Diagnostics
- Upgrading Firmware
- Licensing
- Service and Support
- Warranty
- Appendix A - Serial Ports
- Appendix B – ASCII Character Set
- Appendix C – Control and Status Strings
- Appendix D – Internal Jumper Block
TS4000 Radio Modem User’s Manual Testing 67
Testing
AirTest is Teledesign’s general purpose wireless modem test software. AirTest
can send data and gather performance statistics about the link between multiple
modems.
AirTest is modem independent and can be used with any asynchronous serial
communications device.
To start AirTest press the AirTest button on the main screen of the configuration
program. For details on using AirTest consult AirTest’s on line help.
To test the operation of the TS4000, AirTest can be used to pass data between
two modems.
1) Attach two TS4000s each to a PC serial port.
2) Configure AirTest for serial port settings (baud rate, data bits and parity) that
match the attached TS4000’s settings (Setup Manu – Port Setup).
3) Transmit data between the TS4000s by typing a message into the Tx
Message box of the Comm Port window followed by the ENTER key.
4) Automated tests can be run that will send data and verify that it is received
correctly. To select a test, use the Test Setup command from the Setup
menu. Use the on line help to obtain more information about each test.
AirTest
Data Test