User's Manual

TS4000 Radio Modem User’s Manual GPS Configuration 66
The TS4000 can be configured to periodically output a Morse code identification
string.
Automatic Station ID
Selection Description
Enable
Automatic
Station ID
When the control is selected, the modem will output the ID
message at the designated repeat time.
Repeat Time This is the amount of time between station ID transmissions.
ID Message This is the text message that is transmitted. The
transmission is formatted as standard Morse code.
This is typically set to be a station call sign, license number or
location.
This sets the receive signal level at which the receiver is activated. This is
similar to the squelch control on mobile radios. Normally this level is set slightly
lower than the level at which the TS4000 can correctly demodulate the incoming
data.
Receive Carrier Detect
Lev
el
When using the TS4000 in a high noise environment, this level can be raised so
that the TS4000 is more selective about the signals that it attempts to
demodulate. This is important for configurations that do not allow the TS4000 to
transmit while it is receiving. These include configurations with packet operation
enabled or with the Force Transmit over Receive control disabled.
This mode allows the TS4000 to communicate with Trimble TrimMark and
TrimTalk GPS data links.
Trimble Compatible