User's Manual
Table Of Contents
- Copyright
- Disclaimer
- Emissions
- Table of Contents
- TS4000 Overview
- Configuration Program
- Serial Port
- Radio Setup
- AirNet Packet Protocol
- Overview
- Configuration Options
- Control and Status Strings
- Master-Slave System Setup
- Polled System with Store and Forward Repeaters
- CSMA System Setup
- GPS Configuration
- Testing
- Remote Diagnostics
- Upgrading Firmware
- Licensing
- Service and Support
- Warranty
- Appendix A - Serial Ports
- Appendix B – ASCII Character Set
- Appendix C – Control and Status Strings
- Appendix D – Internal Jumper Block
TS4000 Radio Modem User’s Manual AirNet Packet Protocol 46
Configuration Parameter Setting
Remote Sites - that cannot hear the repeater
Modem Address: Individual
10+ (each remote must have a unique
address)
CSMA MAC Setup-Data Pkts-Min Idle Slots Number of slots for an outbound polling
packet
Number of slots for an outbound polling packet = Packet Transmit Time / Slot Time
Packet Transmit Time = {9 * [Max Outbound Message Length (in bytes) + 14] * Overhead / Air Rate
(in kbps)} + Radio Tx Attack Time (in ms)
Overhead = 1 if Coding (FEC) is Unchecked
Overhead = 1.5 if Coding (FEC) is Checked
Slot Time = 1.5 * Radio Transmit Attack Time
Example:
Max Message Length for Modbus protocol = 255 bytes
Radio Tx Attack Time = 20ms (this value can be read on the Radio Hardware Screen)
Air Rate = 9.6 kbps (this is configured on the Radio tab)
Coding = Unchecked (this is configured on the radio tab)
Slot Time = 1.5 * 20ms = 30ms (this is configured on the Packet General tab)
Packet Transmit Time = [9 * (255 + 14) * 1 / 9.6] + 20 = 273ms
Number of slot for an outbound polling packet = 273/30 = 10 (rounded up from 9.1) (this value
must always be round up)