User's Manual

ManualsBrandsTeledesign Systems ManualsElectronicsRadio Modem

Table Of Contents

Copyright
Disclaimer
Emissions
- FCC
- Notice
- Safety Warning
- RF Exposure
Table of Contents
TS4000 Overview
- Introduction
- Features
- Connections
- Mounting
- Configuring the TS4000
- AirTest - Data Testing
- Upgrading the TS4000 Firmware
- AirScan
- Remote Diagnostics
- AirCalc - Range Estimation
- Status Lights
Configuration Program
- Using Help
- System Requirements
- Installation
- TS4000 to PC Connection
  - Software Connection
- Programming and Retrieving Configurations
- Storing Configurations
- Diagnostics
Serial Port
- RS-232 Serial Port Basics
- Serial Port Connector
- Signal Levels
- Signal Options
- Configuration Options – Serial Port 1
- Serial Port 2
Radio Setup
- Configuration Options
- Frequency Programming
  - Methods of Programming Channels
  - Frequency Configuration Screen
    - Radio vs. File Settings
- Channel Switching
  - Channel Change with a Control String
- Compatibility
AirNet Packet Protocol
- Overview
- Configuration Options
  - Packet General
  - Packet for Port 1 / Packet for Port 2
- Control and Status Strings
  - Control Strings
  - Status Strings
- Master-Slave System Setup
  - Setting Packet Timeout
    - Example
  - Data Packet Transmit Time
    - Example
- Polled System with Store and Forward Repeaters
- CSMA System Setup
GPS Configuration
- Configuration Options
Testing
- AirTest
  - Data Test
  - BER Test
- AirScan
  - AirScan Controls
Remote Diagnostics
- Remote Diagnostics with Repeaters
- Remote Diagnostics Screen
- Remote Diagnostic Controls
Upgrading Firmware
- Upgrading
Licensing
- User’s License
  - USA (FCC)
    - Licensing Service Companies
    - Other Contacts
  - International
- Manufacturer’s Certification
Service and Support
- Contacting Teledesign
- Returning Equipment
Warranty
- Two Year Warranty
- Exclusions
- Limitations
Appendix A - Serial Ports
- Standard Case
  - Serial Port 1 Pinout
  - Serial Port 2 Pinout
- Watertight Case
  - Pinout
    - Notes
- Standard RS-232 Serial Port Pinout
- Standard Usage of the RS-232 Control Signals
- Signal Levels
Appendix B – ASCII Character Set
Appendix C – Control and Status Strings
- General Strings
Appendix D – Internal Jumper Block
- Factory Default Jumper Settings
- Instructions for Accessing the Jumpers
- Jumper Settings for Power on Serial Port 1 - Pin 9
- Jumper Settings for Power on Serial Port 1 - Pin 4
- Jumper Settings for Power on Serial Port 2 - Pin 9
- Jumper Settings for TTL Levels on Serial Port 1

TS4000 Radio Modem User’s Manual AirNet Packet Protocol 36

These configuration options are set using the Packet for Port 1 and Packet for

Port 2 tabs of the Modem Configuration.

Control Description

Individual Address The individual address of this modem.

Group Address The group address of this modem. The group address is

used to isolate different sets of individual addresses. It is

also used to filter group broadcast transfers.

Packet for Port 1 /

Packet for Port 2

Modem Address