User's Manual
Table Of Contents
- Copyright
- Disclaimer
- Emissions
- _
- Table of Contents
- _
- TS4000 Overview
- _
- Configuration Program
- _
- Serial Port
- _
- Radio Setup
- _
- AirNet Packet Protocol
- Overview
- Configuration Options
- Control and Status Strings
- Master-Slave System Setup
- Polled System with Store and Forward Repeaters
- CSMA System Setup
- _
- GPS Configuration
- _
- Testing
- Remote Diagnostics
- Upgrading Firmware
- _
- Licensing
- _
- Service and Support
- _
- Warranty
- _
- Appendix A - Serial Ports
- _
- Appendix B – ASCII Character Set
- _
- _
- Appendix C – Control and Status Strings
- _
- Appendix D – Internal Jumper Block
- _
TS4000 Radio Modem User’s Manual Appendix E – Control and Status Strings 84
Control String Description
broadcast packets regardless of
their source address.
:05,000-000 - the modem will repeat all group
broadcast packets going to group 5
regardless of their source address.
There can be a maximum of 20 addresses in the list.
4) +TSMSF? - query the store and forward setting
Response:
i) +TSRSFA - modem configured to store and forward
all packets
ii) +TSRSFN - modem configured to store and forward
no packets
iii) +TSRSFS - modem configured to store and forward
some packets. The list of addresses
has the same format as the set list
above.
iv) +TSRSFX - invalid setting or the modem is
configured for packet type store and
forward filtering.
+TSMPP Program the configuration parameters into non-volatile
memory.
This process may take as long as 1 second. During this
time, the modem will be unavailable for normal operation.
All numbers are formatted as ASCII digits and sent most significant digit first.
iii - Represents a three digit individual address.
gg - Represents a two digit group address.
nn - Represents a two digit packet number.
Control String Description
+TSI Set for individual transfer.
+TSIAiii Set for individual transfer with address change. The three
address characters change the individual destination
address.
+TSICggiii Set for individual transfer with complete address change.
The first two characters are for the group address and the
remaining three are for the individual destination address.
+TSN Set for individual without acknowledgment transfer.
+TSNAiii Set for individual without acknowledgment transfer with
address change. The three address characters change the
individual destination address.
+TSNCggiii Set for individual without acknowledgment transfer with
complete address change. The first two characters are for
the group address and the remaining three are for the
individual destination address.
+TSG Set for group broadcast transfer.
+TSGAgg Set for group broadcast transfer with address change. The
two address characters change the group destination
address.
Packet Strings
Packet Control Strings