User's Manual
Table Of Contents
- Copyright
- Disclaimer
- Emissions
- _
- Table of Contents
- _
- TS4000 Overview
- _
- Configuration Program
- _
- Serial Port
- _
- Radio Setup
- _
- AirNet Packet Protocol
- Overview
- Configuration Options
- Control and Status Strings
- Master-Slave System Setup
- Polled System with Store and Forward Repeaters
- CSMA System Setup
- _
- GPS Configuration
- _
- Testing
- Remote Diagnostics
- Upgrading Firmware
- _
- Licensing
- _
- Service and Support
- _
- Warranty
- _
- Appendix A - Serial Ports
- _
- Appendix B – ASCII Character Set
- _
- _
- Appendix C – Control and Status Strings
- _
- Appendix D – Internal Jumper Block
- _
TS4000 Radio Modem User’s Manual AirNet Packet Protocol 45
A single repeater system is one where all communication goes through a single
store and forward repeater.
Polling Host
Base
Remote
Repeater
Remote
Remote
Remote
Blind
Remote
Blind
Remote
Configuration Parameter Setting
All Units
Enable Packet Operation Checked
Medium Access Control (MAC) CSMA
Store and Forward Repeater Operation: Repeater Filtering Address
Default Transfer Network Broadcast
CSMA MAC Setup: Data Packets: Tx Index 1
CSMA MAC Setup: Relay Packets: Tx Index 1
Modem Address: Group 1
Base Site
Modem Address: Individual 1
CSMA MAC Setup: Data Pkts: Min Idle Slots 2
Repeater Site
Modem Address: Individual 2
CSMA MAC Setup: Data Pkts: Min Idle Slots 1
CSMA MAC Setup: Relay Pkts: Min Idle Slots 0
Store and Forward Repeater Operation: All Packets Relay All
Remote Sites - that hear the repeater
Modem Address: Individual
10+ (each remote must have a unique
address)
CSMA MAC Setup: Data Pkts: Min Idle Slots 1
Single Repeater
System